G&D TradeSwitch2-USB, Руководство по сборке, установке и эксплуатации

Страница: 58 / 88

Switching
11 · G&D TradeSwitch2-USB
Switching via »CrossDisplay Switching«
With CrossDisplay-Switching ( CDS ), you can use the mouse cursor to switch between
computers.
How to use
CrossDisplay Switching
to switch to another module:
Move the cursor to the edge of an active monitor placed next to another monitor.
The KVM switch switches to the module of the next monitor and positions the cur-
sor. You will barely realize the switching between computers.
When moving the cursor to the outer edges (left edge of Monitor 1 or right edge of
Monitor 3 )
CrossDisplay Switching does not
take place.
If you hold a mouse key while moving the mouse, switching cannot be carried out.
However, you can still drag and drop objects.
IMPORTANT: In the default settings of the KVM switch, »CrossDisplay Switching«
is disabled. If required, enable the function in the setup menu (see page 30).
If you use monitors of the same size and place them next to each other at the con-
sole, you can use the function directly after enabling.
Use the
CrossDisplay-Switching Config Tool to configure both size and order of the
monitors in use if they are of different sizes or not placed next to each other.
NOTE: Depending on operating system and mouse driver, there might be some
restrictions:

Under
Mac OS
, the mouse might jitter at the edge of the screen.

Under
Linux
there might be some problems when placing and moving the
mouse.
EXAMPLE: When moving the cursor to the right edge of Monitor 2 , the KVM switch
switches to the module connected to Monitor 3 .
When moving the cursor to the left edge of Monitor 2 , the KVM switch switches to
the module connected to Monitor 1 .