Installing the HardBoot system
G&D HardBoot plus ·
6
5. Activate the timing of the last slave device and ensure that the timing of the other
slave devices is deactivated. The timing is configured through the DIP switches
5 and 6:
6. Connect the IEC plug of the supplied power cords to the sockets
A
and
B
(see figure 5) on the back panel. Afterwards, connect the shockproof plug to
grounded power sockets.
7. Connect the power packs of the computers and the servers whose power supply is
supposed to be controlled by the
HardBoot CCX
to the sockets 1 to 8. Use an IEC
extension cable for this purpose.
Timing on
Timing off
Socket
A
supplies the connections
1
to
4
with power whereas socket
B
provides
power to the connectios
5
to
8
. It is therefore necessary to connect both power
cords to be able to switch all connections.
Figure 5: Rear view of the
HardBoot CCX
!
Never exceed 10 amp total load for each group of 4 (four) power outlets of
the
HardBoot plus
.
Содержание HardBoot plus
Страница 37: ...NOTIZEN...
Страница 73: ...NOTES...
Страница 74: ...NOTES...
Страница 75: ...NOTES...
