Switching
15
· G&D DVIMUX2-DL-USB
Permanent switching of USB 2.0 devices
In the default settings of the KVM switch, KVM data
and
the data of devices con-
nected to the »USB 2.0 Devices« interface are forwarded to the computer of the
active channel.
Enable USB pinning (see page 43) if you want to permanently switch the data of
devices connected to the »USB 2.0 Devices« interface to a defined channel. The per-
manent switching of these devices (see page 15) remains the same even when
switching the KVM channel.
Enabling permanent switching of USB 2.0 devices
How to permanently switch USB 2.0 devices to a channel:
1. To activate the setup mode, press
Backspace
(default:
Ctrl+Backspace
) at the same time.
If the hotkey delay is enabled, press and hold the key combination for
seven
seconds
.
2. Enter one of the following key combinations:
U1
Permanent switching of USB 2.0 devices to channel 1
U2
Permanent switching of USB 2.0 devices to channel 2
Disabling the permanent switching of USB 2.0 devices
How to disable the permanent switching of USB 2.0 devices:
1. To activate the setup mode, press
Backspace
(default:
Ctrl+Backspace
) at the same time.
If the hotkey delay is enabled, press and hold the key combination for
seven
seconds
.
2. Press and hold the
U
key.
3.
Additionally
, press the key
0
.
IMPORTANT:
Press
U
and
immediately
the
number
of the desired channel.
NOTE:
The LED
Active
shows the switching status (see page 10).
NOTE:
After disabling the permanent switching of USB 2.0 devices, the devices are
switched to the active KVM channel (see page 11).
Содержание DVIMUX2-DL-USB
Страница 51: ...Deutsch...
Страница 99: ...English...
