Gamma Dental Condylograph comfort Set, Инструкция по эксплуатации

Страница: 34 / 60

Instruction Manual
- 34 -
Remove the reference plane adjustment reed
and the reference point indicator. Now you can
insert the upper cast into the corresponding im-
prints in the bite fork. After closing the transfer
stand, you can analyze the distance between
the upper section and the model. Choose the
best-fitting block. Make sure that the layer of
plaster is as thin and even as possible. This will
minimize the distortion effects of plaster expan-
sion.
A mounting plate is fixated to the distance block
using the 2.5 mm Allen key and nut. Open the
transfer stand and fit in the distance block.
Moisten the model, and make sure to apply an
adequate amount of plaster on both the mount-
ing plate and the model. Close the transfer
stand, and allow the plaster to harden, following
the manufacturer’s instructions.
Now, you can remove the model from the trans-
fer stand and insert it into the Reference SL ar-
ticulator, for mounting the lower jaw model.