GAMMA & BROSS HYDROLOUNGE, Руководство пользователя

Страница: 11 / 29

- HYDROLOUNGE PEDICURE CHAIR User’s Manual –
GAMMA & BROSS spa - Via Mazzini,62/E- 46043 CASTIGLIONE DELLE STIVIERE (MN)
11
The different parts of the HYDROLOUNGE PEDICURE CHAIR packaging must be lifted manually by two
people. If some kind of lifting device is used, check for the correct balance of the load, until it is completely
lifted, and proceed with a constant movement with no jerks or thrusts.
Keep the load as low as possible during movements for better load stability and greater visibility. The
manufacturer is not responsible for breaks during the transportation of the
HYDROLOUNGE PEDICURE
CHAIR .
3.2 UNPACKING
Take the packed equipment as near as possible the place in which it will be installed and take out the packing
parts. If the packaging is made of paper, place it in the corresponding containers for separate collection and
recycling. If the packing is made of plastic (nylon air ball), do not burn or throw it out in the environment, but
dispose of it in the corresponding collection points, according to the current legislation in the user’s country.
Keep packaging components out of the reach of children as they are potentially dangerous.
3.3 INSTALLATION
The operations to install the HYDROLOUNGE PEDICURE CHAIR are described below. Before installation,
check that the equipment is complete and in good conditions.
- The installation and adjustment of the HYDROLOUNGE
PEDICURE CHAIR involve dangerous operations: only
skilled responsible personnel must carry out these
operations.
- Read carefully the instructions specified in this booklet:
GAMMA & BROSS shall not be held responsible for
damages resulting from the non-compliance with such
instructions.
- Electrical and hydraulic checks and connections must only
be carried out by qualified personnel in compliance with
the regulations in force.
3.4 CHECKING BEFORE MOUNTING
Before mounting HYDROLOUNGE PEDICURE CHAIR , it is necessary to check and, if necessary, adjust the
systems in the installation room, and observe the following measures:
- Check operation voltage and frequency: they must coincide with the power mains voltage and
frequency in the room. The electric equipment is generally set to operate at a 230-volt voltage, and 50-
hertz frequency.
- Check the state of the power supply cable conductors and earth cable.
- Check that an automatic cut-out device with an emergency cut-out switch for overcurrent has been
installed.
- Connect the equipment cable to the power socket with extreme care according to the regulations in
force.
- Voltage drops and devices that cause electromagnetic interference may damage the electronic parts of
the HYDROLOUNGE PEDICURE CHAIR .
- Provide a double-pole differential circuit breaker with minimum opened contacts.