40
7100 Series Installation/Operating Manual —
P/N 9000-0447:J 08/28/08
Basic System Module (BSM)
Telephone Requirements
3.10 Telephone Requirements
The following list the telephone requirements:
•
DC Ringer Equivalence Number (REN) = 0.5B
•
AC Ringer Equivalence Number = 1.3
•
Complies with FCC Part 8
The REN is used to determine the quantity of devices that may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an
incoming call. In most, but not all areas, the sum of the RENs should not exceed five (5). To be
certain of the number of devices that may be connected to the line, as determined by the total
RENs, contact the telephone company to determine the maximum REN for the calling area.
3.11 Digital Communicator
Before connecting the 7100-D to the public switched telephone network, the installation of two (2)
lines are required. The following information is provided if required by the local Telephone
Company:
3.12 Telephone Company Rights and Warnings
The Telephone Company, under certain circumstances, may temporarily discontinue services
and/or make changes in its facilities, services, equipment or procedures which may affect the
operation of this digital communicator. However, the Telephone Company is required to give
advance notice of such changes or interruptions. If the digital communicator causes harm to the
telephone network, the Telephone Company reserves the right to temporarily discontinue service.
Advance notification will be provided except in cases when advance notice is not practical. In such
cases, notification will be provided as soon as possible. The opportunity will be given to correct
any problems and to file a complaint.
•
When the digital communicator activates, premise phones will be disconnected.
•
Two separate phone lines are required. Do not connect both telephone interfaces to the same
telephone line.
•
The digital communicator must be connected to the public switched telephone network
upstream of any private telephone system at the protected premises.
•
This equipment is designed to be connected to the telephone network or premises wiring via
terminal blocks.
Manufacturer:
Gamewell-FCI
12 Clintonville Road
Northford, CT 06472-1610 USA
Product Model Number: 7100-D
FCC Registration Number: 6KWUSA-34215-AL-T
Ringer Equivalence: 0.5B
!
WARNING: DO NOT CONNECT THIS PRODUCT TO COIN TELEPHONE, GROUND START OR
PARTY LINE SERVICES.
