GAME SolarPRO XB, Руководство пользователя

Страница: 8 / 12

8 SAVE THESE INSTRUCTIONS
7. TROUBLESHOOTING
Problem Possibilities/Solutions
Does not appear to be heating
the pool
• Check to make sure that water is flowing through the water channels. Check the flow
strength at the pool inlet
• Has it been sunny?
• Put your pool cover on at night to prevent heat loss.
• Additional heaters and bypass kit may be necessary.
No initial bubbling after heater is
connected and pump is on
• Check the setting of the filter to make sure it is returning water to the pool through the
pool water inlet
• Check flow rate.
Bubbles continue to flow out of the
pool water inlet well after the pump
has been turned on
• Check the connections for a suction leak.
• Check to make sure the flow rate is normal.
• There could be a break in the tubing.
• There could be a clog in the tubing, try to purge out
the clog
Dripping or leaking from connectors
• Check the connector seals and o-rings and replace or repair if defective.
• If the heater is punctured, use the included repair kit, or a kit made for PVC pool or
waterbed repair, to patch the puncture
• Tighten the elbow connectors by hand.
• Coat all seals and o-rings with a thin layer of gasket lubricant, available at your local
hardware or pool store
High pump pressure • Flow through heater may be too high. A bypass kit may be needed.
• Filter may need to be replaced, cleaned or backwashed.