Instruction Manual : 15’ LADDER STAND
16
INSTALLATION AND USE INSTRUCTIONS
1. With assembled product lying on the ground, position
one person at bottom end of ladder lying on the
ground. This person has to prevent the ladder end
from tilting up when platform end is lifted and prevent
the ladder from skidding across ground.
2. a. Position two people at the platform end of the
ladder, lift the platform end and continue uprighting
by walking toward bottom end of ladder and moving
hands along ladder legs. Stand ladder up against
chosen straight tree on dry, level ground. Use
caution when ladder comes over center against the
tree. SEE FIGURE 9A.
b. Step back and look at the ladder top to see that it is
level. Adjust as needed to achieve a level platform top.
Make sure tree blade is contacting tree. SEE FIGURE
9B.
c. Step down hard on bottom step to push ladder legs
into the ground. SEE FIGURE 9C.
STEP 1
FIGURE 9
WARNING
Never use a treestand on a dead, leaning, diseased or
loose barked tree, or a utility pole. Always avoid electrical
power lines.
Bring ratchet strap(s) up with you in a pocket - Do Not
carry in your hands!
During installation and removal of ladder treestands, you
must always and properly use the included Full Body Harness
(Fall Arrest System). Refer to the Full Body Harness instructions
included with this product for proper use.
A
A
C
B
3. While two people holding the stand in place, the
third person should connect the horizontal stabilizer
bar to the tree. Adjust the length of the stabilizer bar
as needed so it contacts the tree and is level to the
ground. Then secure it to the tree with the 6’ cam strap
(17) by forming a cinch knot with both ends of the
strap and running the long end of the strap through
the cam buckle. SEE FIGURES 10A AND 10B.
FIGURE
10A
FIGURE
10B
STEP 2