Charging the Battery Pack
Checking the Power Level
Step 1 -
Press the fuel gauge button to display LED lights.
IMPORTANT- Activate the LED lights by
pressing and holding the fuel gauge button
for 20 seconds.
Step 2
Verify power level by viewing LED Light Indication chart
on page 3 of this Use Guide.
Prior to Use
Step 1
After the Battery Pack has been charged, take the
Battery Connector Cable and gently press the barrel
plug (marked on cable) into the DC port on the
Battery Pack.
Step 2
Plug the other barrel plug in the Game Ready
Control Unit. (As shown) The Control Unit is now
ready for approximately seven hours of treatment
time.
Step 3
Unplug the Connector Cable from the Game Ready
Control Unit immediately after each use to prevent
battery drain and to preserve the battery integrity.
Using the Battery Pack
Control
Unit
LED Light Indication
Sleep
Time
Time
Run
Ice Bath
Temp.
Pressure
Off
Low
Med
High
Avg. W
rap
Temp.
55/13
50/10
45/7
40/5
ºF/ºC
Connec
t t
o
Con
trol U
nit
Connec
t to
Batter
y
Page 3
Page 2
Charging:
Step 1) Insert the barrel plug end of the AC Charger into the DC Port located on the Battery Pack.
Step 2) Insert the wall plug into an AC wall outlet.
PLEASE NOTE: The AC Charger will display a red light during the charge cycle. Once the light changes
to green, the Battery Pack is completely charged and ready to use.
Step 3) Disconnect the barrel plug from Battery Pack, it is now ready to use.
fuel gauge
button
573197 - Rechargeable Battery Pack Kit
573197 - Rechargeable Battery Pack Kit
Connect to Battery
DC Port
Insert barrel plug
Battery Connector Cable
Connect barrel
plug to Battery
Pack
Connect barrel plug
to Control Unit
Plug into AC wall outlet
Recharge Time:
The Battery Pack will require approximately 4-5 hours to fully charge, or less time for a partially charged Battery
Pack.
Light = Red (during charge)
Light = Green (charge complete)
Prior to first time use, the Battery Pack must be fully charged per the instructions below!
Power Meter -
Press the fuel gauge button to confirm the remaining power available on the Battery
Pack as shown:
4 Green LEDs = 75 - 100% power remaining
3 Green LEDs = 50 - 75% power remaining
2 Green LEDs = 25 - 50% power remaining
1 Green LED = Less than 20% power remaining
The flashing red LED light indicates low power, the Battery Pack
needs to be recharged.
fuel gauge
button
Battery Pack
