EN-14
Control Unit
The exterior of the Control Unit and the visible interior surfaces of the reservoir can be
cleaned with a soft cloth and one of the following cleaning agents:
•
Mild detergent
•
70% Isopropyl alcohol
•
100% Simple Green®
•
Quaternary ammonium (such as Virex® – typically only found in a clinical use setting)
•
Cavicide®
procedure:
•
Follow the manufacturer’s instructions and precautions for the cleaning agent you select.
•
Apply the selected cleaner to a soft cloth and wipe down all surfaces of the Control Unit.
•
Allow the Control Unit to dry thoroughly before storing it in the bag.
•
The Control Unit should be cleaned as needed.
do not USe:
•
Phenolic-based disinfectants (such as Amphyl® – typically only found in a clinical use
setting).
•
Any solvent-based cleaners on the Control Unit. Doing so will damage the plastics and will
void your warranty.
•
Abrasive materials to clean the Control Unit. Doing so will damage the plastics and will
void your warranty.
Caution
: The Control Unit is not a waterproof device. Do not apply a direct stream of any
liquid onto the Control Unit, submerge the Control Unit, or allow any liquid to pool on the
surface of the front panel of the Control Unit.
ConneCtor HoSe
The surface of the Connector Hose can be cleaned using a soft cloth and one of the
following:
•
Mild detergent
•
Steri-Fab®
•
70% Isopropyl alcohol
•
We do not recommend the use of quaternary ammonium (such as Virex®) or Cavicide.®
do not USe
:
•
Phenolic-based disinfectants (such as Amphyl® – typically only found in a clinical use
setting).
•
Any solvent based cleaners. Doing so will damage the plastics and will void your warranty.
•
Abrasive materials. Doing so will damage the plastics and will void your warranty.
•
Any petroleum based lubricants. Doing so will damage the o-rings and will void your
warranty. If lubrication is required, the use of silicon spray is recommended.
WrApS
Gently remove Heat Exchanger from the Sleeve. Hand wash the Sleeve in cold water,
using a mild detergent or antibacterial soap. Do not use fabric softener. Hang to dry.
If needed, the external surface of the Heat Exchanger may be cleaned by wiping down with
commercial non-bleach cleaning wipes or hand washed using a very small amount of mild
detergent or antibacterial soap. DO NOT MACHINE WASH.
Refer to the Wrap Use Guide accompanying individual Wraps for more information.
C l e A n i n G