Adjusting the keyboard tray position
1. The keyboard tray is shipped in the position shown above. The tray can be
repositioned to the lower position or it can be repositioned forward or
backward 1" by removing the 1/4" mounting hardware on each side of the
tray and relocating the tray to the desired position. Make sure to reuse both
1/4" hex bolts on each side of the tray to secure it in place when done.
Attaching the keyboard to the tray with dual lock
The keyboard can be attached to the tray using (4) 8" to 10" long pieces of
Dual lock faster supplied in hardware bag 7120-0714.
Cut the Dual lock strip into (4) 8" to 10" pieces. Lock the 4 pieces of dual lock
fastener together to make 2 attached strips with the release liners toward the
outside.
Remove the release liner from one side of each attached strip and attach to
the bottom of the keyboard.
With the 2 assembled strips attached to the bottom side of the keyboard,
remove the 2 remaining release liners. Position the keyboard above the
keyboard tray in the desired position and press the keyboard down firmly to
adhere the strips to the keyboard tray.
To remove the keyboard from the tray, hold both sides of the keyboard and
pull away from the tray. The dual lock strips will separate from each other.
To reattach the keyboard to the tray, realign the dual lock strips and press
downward on the keyboard to snap the dual lock strips back together again.
1/4" hex bolts & washers
(2 each side)
keyboard
dual lock
strips
Keyboard tray
