G
AMATRONIC
E
LECTRONIC
I
NDUSTRIES
L
TD
.
GMAC 5 User Guide
19
5.6
Define a shutdown target
Use this screen to define a network-connected computer that is to be automatically shut down under certain
conditions.
In order for the shutdown to take place, the Shutdown Agent must be installed on the target computer. The
Shutdown Agent can be downloaded from the link on this screen, or can be obtained from your dealer.
Figure 19: Define a shutdown target
Table 5: Key to Figure 19
F
IELD NAME
D
ESCRIPTION
Target address
IP address or name of the computer to be shut down. The command is sent in UDP;
the default port is 262. You can set a different port by adding a colon and the
alternate port number after the name or the address. Be sure to configure the
Shutdown Agent on the remote computer to use the same UDP port.
On ac input failure
Following an ac input failure, a shutdown command is sent to the target computer
after the specified time interval.
On low battery
Following a low-battery alarm, a shutdown command is sent to the target computer
after the specified time interval.
On alarm group
Following the occurrence of any of the alarm conditions in the indicated alarm group,
a shutdown command is sent to the target computer after the specified time interval.
Wake on LAN
Specify a time interval and the target computer’s MAC address. The target computer
will receive a “wake up” command after the specified time interval following return of
the ac power mains. Use port 7 or 9 as instructed by your network manager. The MAC
address can be entered in the format “01:23:45:67:89:AB”, or with dashes instead of
colons. The MAC address field is case insensitive.
