18
Base Menu description:
Operating logic
OL:
Select
OL
and push enter, with up/down select wanted logic between following end push once
enter. Check tab operating logic for further information.
5T:
Step by step logic.
At:
Automatic closing with stop function.
CD:
Automatic closing for condominium function.
To exit this menu select
EX
or push up/down together.
LC Learning/ removing transmitters code:
Select learning code function
LC
and push enter, than select one of following functions with
up/down.
C1:
learn a transmitter on channel1.
C2:
learn a transmitter on channel2.
Rt:
Delete all transmitter in memory.
Once selected the channel transmit the code, on the display is show
“
OK
” for a while if operation is
done.
To replace the channel of a code, just select desired channel and transmit once the same code.
To delete just one code, select
RT
and transmit the code to be removed, on the display is show
“
OK
” for a while if operation is done.
To delete all codes, select
RT
and push enter, then confirm with
YS.
To exit this menu select
EX
or push up/down together.
LT learn working time:
Attention:
before to start learning procedure, the gate must be open to do automatic procedure,
otherwise must be closed to do the manual procedure. Use
“dead man ” function to put the gate in
the right position.
Is it possible to program working time automatically, please refer to
“
Quick installation
”
Select
LT
in the base menu and push enter, after select the learning mode with up/down.
AU:
automatic learning procedure.
MN:
Manual learning procedure.
To exit this menu select
EX
or push up/down together.
AU: Automatic procedure for working times learning.
Attention: in this procedure all safety inputs are disabled.
The wings close themselves, in the meanwhile all the working times and values for obstacle
detection sensor are learned. If just motor 2 is connected, the control unit sets itself for
“single wing
working
”. If analogue edges are connected, they are automatically enabled.
5p Set pause times:
Use up/down to set the pause time between 0 and 99 seconds. Push enter to confirm. To exit
without modifications push together up and down.
Attention: setting pause time doesn’t enable auto closing, please refer to chapter “OL operating
logic” to enable this function.
