Assembly Instructions
Operation Instructions
page 3
NOTE: If you are replacing an existing gas/
electric post light, you must consult a
certified technician to disconnect them
before installation.
• Remove the top (C) from the fixture (D) by
unscrewing the four screws.
• Install the GS Solar LED Bulb into the top (C)
by twisting it clockwise. Be sure to hold the
bulb by its base.
• Turn the lamp on using the operation switch
located on the underside of the top (C).
• Re-install the top (C) back to the fixture (D)
by tightening the four screws.
• Install the desired finial (A or B) to the top
(C) by twisting clockwise.
• Place the lamp on your existing 3” pole and
secure with the provided set screws.
NOTE: Be sure to not overtighten the screws.
1. Install the GS Solar LED Bulb in the top
(C).
2. Locate the operation switch on the
underside of the top (C).
3. Turn the operation switch to the Low
or High position according to your
preferences:
- Low = Softer light and longer duration
- High = Brighter light output
The solar Lamp will automatically operate
at dusk.
Replacement Parts
Replacement Batteries and Bulbs are
available at www.gamasonic.com or via
our Toll Free number: +1-800-835-4113.
Your Lamp can use the following bulbs:
A60WW20W – included bulb with Warm
White LEDs (2700K)
A60BW20W – bulb with Bright White
LEDs (6000K)
F30WW05W –Flame bulb with simulated
flame LEDs
T45WW10W – Edison LED Bulb with
Warm White LEDs (2700k)
Your Lamp uses two of the following
battery:
GS32V30
This lamp has the option to use two additional
batteries which can help extend duration if the
lamp receives more than four hours of direct
sunlight.
3" pole
A
or B
C
D
