GS-98P
Use electric drill to make two holes in the desired surface, place provided
anchors into holes, place the base (L) in line with the holes and screw the
provided screws.
GS-98F
NOTE: If you are replacing an existing gas/electric post light, you must consult a
certified technician to cancel them before installation.
Place Part (M) on top of your existing 3” post and tighten the 3 screws
provided to secure the lamp.
GS-98W
NOTE: locate your solar lamp facing the south for best results.
Use electric drill to make two holes in the wall, place provided anchors into
holes, place the wall bracket (N) in line with the holes and screw the provided
screws.
Replacing the Batteries
(After several years of use, the batteries may need replacing).
1.
Unscrew the two knobs in the upper part of the lamp (B) to detach it
from Part A.
2.
Make sure the ON/OFF switch is in the “OFF” position (0).
3.
Unscrew the battery compartment’s screw located on the silver reflector
and remove the old battery pack. Make sure the new batteries are high
quality – 1 x Li-Ion Battery Pack (3.2 Volt / 1500 Ma) (Fig. 1).
4.
Install the new batteries into the battery compartment.
5.
Reassemble the unit by reversing the above procedure.
Charging & Duration Chart
WARNING
: Do not dispose of Li-Ion battery in the regular trash, municipal waste
stream or by fire as batteries may leak or explode. Do not open, short circuit, or
mutilate batteries as injury may occur. Preserve our environment by recycling Li-Ion
batteries or disposing of them in accordance with local, State and federal regulations.
Do not mix old and new batteries.
Model#
Charging
Time
Duration
High Mode
Duration
Low Mode
GS-
98L/S/D/T/W/F/P
3 Hours
Approx. 6 hours
Approx. 8 hours
6 Hours
Approx. 10 hours
Approx. 15 hours
