GS-104P
Use electric drill to make two holes in the desired surface, place provided
anchors into holes, place the base (L) in line with the holes and screw the
provided screws.
GS-104F
NOTE: If you are replacing an existing gas/electric post light, you must consult a
certified technician to cancel them before installation.
Place Part (M) on top of your existing 3” post and tighten the 3 screws
provided to secure the lamp.
GS-104W
NOTE: locate your solar lamp facing the south for best results.
Use electric drill to make two holes in the wall, place provided anchors into
holes, place the wall bracket (N) in line with the holes and screw the provided
screws.
Replacing the Batteries
(After several years of use, the batteries may need replacing).
Unscrew the two knobs in the upper part of the lamp (B) to detach it from Part A.
1.
Make sure the ON/OFF switch is in the “OFF” position (0).
Fig. 3
GS-104S/D
Fig. 4
Fig 1.
