3. Assembly Instructions
page 3
1. Remove the base plate (H) from the base pole (A) by
removing the screw caps, nuts, and washers from each of
the three screw studs.
Installing in concrete
- Using the base plate (H) as a template and mark where
the three holes will need to be drilled.
- Drill three holes in the concrete no larger than the
provided anchors.
- Insert the three anchors into the holes and secure
the base pole to the concrete by tightening the three
anchors.
- Continue to Step 2
Installing using the EZ Anchor
- Place the turning (I) bar through the hole at the top
of the auger (G) and begin twisting the auger (G) into
the ground clockwise. Use downward pressure while
turning.
- Occasionally check the level tool on the auger (G) to
ensure the auger is vertical.
- Stop turning once the ring on the auger (G) is flush
with the ground.
- Slide the base plate (H) over the auger and secure it
with the large nut and bolt.
- Re-install the base pole (A) to the base plate (H) and
secure with the washer, nut, and screw caps removed
in step 1.
2. Attach the middle pole (B) to the base pole (A) and secure
with the three provided screws.
3. Attach the top pole (C) to the middle pole (B) by screwing
them together.
4. Attach the spacer pole (D) to the top pole (C) by screwing
them together.
5. Attach the fitter adapter (E) to the spacer pole (D) by
screwing them together.
6. Mount your 3” lamp to the fitter adapter (E) and secure
using the setscrews on the lamp.
E
F
or
D
C
B
A
H
G
