Assembly Instructions
Operation Instructions
page 3
3” Fitter Mount
NOTE: If you are replacing an existing
gas/electric post light, you must
consult a certified technician to
disconnect them before installation.
• Slide the fixture (B) over your existing
3” post.
• Tighten the set screws to secure the
lamp in place.
NOTE: Do not over-tighten the set
screws.
• Follow the Operation Instructions to
turn the lamp on.
Pier Base Mount
Note: There are specific types of screws
for specific surfaces. If unsure of the
appropriate type of screw to use on
your desired surface, please consult a
professional.
• Using the pier base (C) as a template,
mark where the two holes will need to
be.
• Drill two holes no larger than the
included anchors.
• Place the anchors
into the holes and
secure the pier
base (C) using the
provided screws.
• Attach the fixture (B)
to the pier base (C)
by tightening the set
screws.
NOTE: Do not over-
tighten the set
screws.
• Follow the Operation
Instructions to turn
the lamp on.
• Remove the top (A) by twisting counter
clockwise.
• Insert the GS Solar LED Bulb by twisting
clockwise.
• Move the operation switch to the Low
or High position according to your
preferences:
• Low = softer light and longer duration
• High = brighter light output
• Reattach the top (A) to the fixture (B)
• The solar lamp will automatically operate
at dusk.
Replacement Parts
Replacement batteries and bulbs are
available at www.gamasonic.com or via
our Toll-Free number: +1-800-835-4113.
Your Lamp can use the following bulbs:
C37WW10W – included bulb with Warm
White LEDs (2700K)
C37BW10W – bulb with Bright White
LEDs (6000K)
F30WW05W –Flame bulb with simulated
flame LEDs
T45WW10W – Edison LED Bulb with
Warm White LEDs (2700k)
Your lamp uses the following battery:
GS32V15
!
!
!
!
!
!
!
!
!
!
