7
-after striking a foreign object. Inspect the machine for damage and make repairs before restarting and operating
the machine;
-if the machine starts to vibrate abnormally(check immediately);
Always mow slopes at right angles to the incline; never mow up and down
Caution: do not touch running cutters.
Never open the guard flap while the motor is still running.
Assembly
Collector part assembly (fig.A1)
1.Press the handle (1) into collector cover(2),
2.place the collector cover on the collector base(3) from above in such a way that all the eyes are positioned over
the hooks.
3.Press the collector cover on the collector base until the hooks engage securely.
4.Inspect
：
Check that all the hooks are engaged securely.
Assembling bottom handle part(fig.A2)
Put the bottom handle(A) into chassis holes(B), then insert securing screw ST4.7X16 (C) from inside through the
bottom handle, so that both projections catch in the recesses.
Assembling top of handle(fig.A3)
Attaching switch, strain relief and clips(fig.A4/A5)
Fold up switch bracket and position switch on the upper handle element so that the two nubs catch in the holes .
Close switch bracket . Then fasten switch with the two screws ST4X16. fasten switch cable with the clips on the
handle rod.(fig.A4)
Operation
Operating times
Please check noise abatement regulations prevailing in your country.
Inserting power cable into cable holder (fig.A6)
Insert the power cord into the strain relief as shown in the illustration.
Connecting to the mains
The mower operates from any normal household mains supply
(230 Volt AC., 50 Hz), provided with a 13 Amps. fuse.
Note:
Use a residual current device (RCD) rated for a residual current not greater than 30 mA.
Collector (Fig.A8)
Fitting
Lift the deflector guard and hold up, fit the collector.
Removing/emptying
Lift the deflector guard and hold up. Remove collector.
For non grass collection the mower can be used without the collector in position, with the deflector guard in the
down position.
Setting the working depth (Fig,A9)
Stop, release switch lever and wait until the motor stops before adjusting height. The
blades continue to rotate after the machine is switched off, a rotating blade can cause
injury
For the first cutting of the season, a high cutting adjustment should be selected.
You machine has five settings that result to the following cutting heights.
Ⅰ
=25mm
Ⅱ
=35mm
Ⅲ
=45mm
Ⅳ
=60mm
Ⅴ
=75mm
Important!
The front and back wheels must be set to the same height.
Starting and Stopping (Fig.A7)
The blade continues to rotate for a few seconds after the machine is switched off. Allow the
motor/blade to stop rotating before switching
“
on
”
again.
Содержание GLM-43E
Страница 1: ...1 ELECTRIC LAWNMOWER Instruction manual GLM 43E...
Страница 2: ...2...
