The Great American Market (GAM) - Home
http://www.gamonline.com/catalog/twinspin/instruct.php
1 of 2
8/2/04 3:02 PM
INTRODUCTION
Congratulations on your new TwinSpin II. It will add an exciting new dimension to your pattern
projections: motion. Now you can create dynamic special effects quickly and easily.
PREPARING THE FIXTURE
Before inserting patterns or a TwinSpin II in your fixture, it is important to align the lamp. Position it
in the reflector so that the circle of light is as smooth and even as possible. When the field of light is
truly flat, it will appear a tiny bit darker in the center (this is an optical illusion).
When the lamp is positioned too far into the reflector, the center of the field will look hot. When the
lamp is positioned too far back out of the reflector, the center will be dull and shadowed and the
outer rim will look bright and harsh. 'Hot spots' cause premature warping of the patterns and may
damage delicate designs.
INSERTING PATTERNS IN THE TWINSPIN
With TwinSpin II lying on a flat surface, center a pattern in the shallow well on the lip of the circular
opening. Then secure with a retaining ring.
Begin by pushing one end of the ring into the groove in the corner of the lip. Hold firmly in
place with your finger, pressing the ring against the pattern.
Holding the ring firmly, work the ring around until it is all in place .
Finally, allow the hooked end to snap into place. To avoid pinching your finger, hold a small
screwdriver straight against the wall of the lip near where the notched end will land. You may
press the ring down gently with your finger to make sure it is tight all the way around. Turn
TwinSpin II over and repeat on other side.
Inserting retaining ring
TIP
When using older warped patterns, be sure they are bent away from each other in the TwinSpin so
they can't catch on each other while rotating.
INSERTING TWINSPIN II IN THE FIXTURE
First, be sure that the lamp is properly aligned. Then slide the TwinSpin II straight down into the iris
slot just in front of the pattern holder. Be sure it is seated straight and as far down as it will go.
Secure the TwinSpin II cord so it does not contact the fixture housing.
CONTROL
USING LINE VOLTAGE - You can plug your TwinSpin II transformer directly into any 120V AC line and
the patterns will rotate at full speed.
