page 3 -
GVO2315
2: Back Wall
4: End Walls
If you choose to vary from these instructions your warranty will be impaired.
3: Roof
2: Back Wall
A. Join 3 (a) sheets together with 2
fixings through the overlapping
ribs making sure the ends of the
sheets are flush.
B. Cap sheeting with (e) channels .
C. Fix the channels through the
end ribs and every 2nd rib be-
tween.
D. Make sure you put at least 1 fix-
ing per sheet up through the
underside of the channel into
the pan of the sheet.
(
a
)
(
e
)
(
e
)
You need:
2 x (e) Channels
3 x (a) Sheets
(e)
(e)
(j)
(j)
You need:
2 x (e) Channels
3 x (a) Sheets
2 x (j) “L”s
(
a
)
A. Join 3 (a) sheets together same as
the back.
B. Cap sheeting with (e) 2255mm
channels.
C. Fix the channels every 2nd rib but
not the corners at this stage
D. Place the short flange of the “L”
on top of the rib at 1 end. Make
sure ends are flush with sheeting
and put 1 fixing in the centre to
hold the “L”. Fix the corners
through the channels and 1 more
between the corner and the cen-
tre fixing. Perform the same at the
other end. 5 fixings ea “L”
A. Join 2 Left (b) sheets together
to give a slope at the top.
B. Cap sheeting with (f) 1485mm
channels.
C. Fix the channels through the
end ribs and every 2nd rib be-
tween.
D. Make sure you put at least 1
fixing per sheet up through the
underside of the channel into
the pan of the sheet.
E. Perform the same again for
the Right side.
(f)
(b)
You need:
2 x (f) Channels
2 x (b) Sheets
(f)
(b)
(f)
Channels will end
20 - 30mm short
at tops of end
walls and 15 - 20
at bottoms
