Version 1, 11 July 2017, Page
2
of
5
PRE-INSTALLATION
Body:
If the mounting holes do not already exist, mark
out and drill the holes in the bench, as shown.
This model is a dual inlet unit requiring a hole
diameters of 23mm - 26mm, 205mm apart. Ensure
70mm minimum between wall and hole center as
shown “A”.
Maximum bench thickness is 55mm.
Wall Bracket:
Mark out the three (3) holes for mounting the wall
bracket assembly at a height of between 420mm
min - 510mm max directly up from the bench. Cut
out or drill as shown in the image. (Supplied
fasteners may not be suitable for the mounting
surface. If this is the case, suitable fasteners will
need to be sourced by the installer)
Note: We recommend the wall bracket is installed
at the maximum of 510mm. The wall bracket can be
mounted lower at a height of up to 90mm below the
circlip. However, the further it is mounted away
from the circlip, the more the stability of the unit is
compromised.
MOUNTING DETAILS
TF83HJS – Assembly
TF83HJP - Assembly