Version 2, 16 August 2017, Page
2
of
4
PRE-INSTALLATION
MOUNTING DETAILS – HOLE CENTRES
If the mounting holes do not already
exist, mark out and drill the holes in the
bench/trough, as shown in rough-in
dimensions.
Ensure alignment of 5mm hole is
as shown, as this will determine
the direction of the water flow.
Note: Before installation, all lines must
be flushed. We recommend that a line
strainer be installed prior to drinking taps
to eliminate any foreign material.
INSTALLATION
IMPORTANT:
Galvin Specialised products must be installed in accordance with these installation
instructions and in accordance with AS/NZS 3500, the PCA and your local regulatory requirements. Water
and/or electrical supply conditions must also comply to the applicable national and/or state standards.
Failing to comply with these provisions shall void the product warranty and may affect the performance of
the product.
1. Fit tap assembly
Fit the outlet into the bench.
Ensure the rubber sealing washer is
placed underneath the outlet body and
the anti-rotation pin locates properly.
Secure underneath with the supplied cup
washer and back nut.
2. Flow adjust
To adjust water flow
1. Remove the blanking screw
2. Adjust the water height by turning the
regulator screw
3. Replace blanking screw
Note: The full range from minimum flow to maximum
flow is only ¼ turn
139
1/2" BSP
ANTI
-ROTATION
PIN
91
59
50
16.0
5.0
DRILL
23mm Min.
26mm Max.