Specialised commercial taps and valves
© Galvin Engineering Pty Ltd: 2013 (Issue 07/2015)
CliniLever
®
Healthcare Tapware
410 Victoria Rd, Malaga, WA 6090
Within Australia:
1300 514 074
Outside Australia:
+61 (0)8 9249 5900
Fax:
+61 (0)8 9249 5916
Email:
www.galvinengineering.com.au
PERTH I SYDNEY I MELBOURNE I BRISBANE I ADELAIDE
ABN: 78 008 719 382
A business unit of
TM-BASCP
As supplied, this mixer delivers full flow hot and cold
water. To use the anti-scald feature adjust the stop ring
as follows:
1. Remove indicator plug (3). Using 2.5mm allen key
(4) loosen screw (2) and remove handle (1). Unscrew
cap (5) taking care not to damage the chrome finish.
2. Using a small screwdriver, carefully remove the red
stop ring (7) and reposition it in an anti-clockwise
direction as required so that the spline teeth in the
stop ring (7) engage with the spilne teeth on the
cartridge (8). As a guide, rotate the stop ring (7) by 1
spline in an anti-clockwise direction. This will restrict
the handle movement in the hot water direction by 8
degrees of rotation. Push the stop ring (7) fully down.
3. Check the hot water temperature with the handle
in the fully open hot water position. If required
adjust the stop ring (7) until a satisfactory hot water
temperature is achieved. Ensure stop ring is fully
pushed down.
4. Replace cap (5), tighten by hand. Fit handle (1)
taking care that it is pushed fully down. Tigthen grub
screw (2) and replace handle plug (3).
Adjusting the Anti-scald Stop Ring
(Fig 2)
Replacing Aerator Insert
1. Carefully remove aerator housing (17) from mixer
body (9) taking care not to damage the decorative
finish.
2. Remove seal (19) and aerator insert (18) from aerator
housing. Check that aerator housing is clean and
clean any debris that is blocking the flow.
3. Fit new aerator insert (18) into aerator housing (17)
followed by seal (19) then screw assembly into mixer
body (9) and tighten securely (to prevent removal by
hand).
July 2015
