© Galvin Engineering Pty Ltd
Version 1, 2 June 2022, Page
4
of
4
Product Installation Guidelines
Version 1, 2
nd
June 2022, Page
4
of 4
5. Check Shower for operation and leaks
Check the hose is securely connected. Turn on water supply, the shower should now be working. Once
installation is completed and the unit must be tested for any leaks.
To comply with backflow prevention standards, the hand spray must hang at least 55mm above the
floor provide an ‘air-gap’ (See Figure 1). If the hand piece lies on the floor, then an appropriate
backflow prevention device must be installed
.
WARRANTY
The warranty set forth herein is given expressly and is the only warranty given by the Galvin
Engineering Pty Ltd. With respect to the product, Galvin Engineering Pty Ltd makes no other warranties,
express or implied. Galvin Engineering Pty. Ltd. hereby specifically disclaims all other warranties,
express or implied, including but not limited to the implied warranties of merchantability and fitness for a
particular purpose.
alvin Engineering Pty Ltd products are covered under our manufacturer’s warranty available for
download from www.galvinengineering.com.au Galvin Engineering Pty Ltd expressly warrants that the
product is free from operational defects in workmanship and materials for the warranty period as shown
on the schedule in the manufacturer’s warranty. During the warranty period, alvin Engineering will
replace or repair any defective products manufactured by Galvin Engineering without charge, so long as
the terms
of the anufacturer’s warranty are complied with.
The remedy described in the first paragraph of this warranty shall constitute the sole and exclusive
remedy for breach of warranty, and Galvin Engineering Pty Ltd shall not be responsible for any
incidental, special or consequential damages, including without limitation, lost profits or the cost of
repairing or replacing other property which is damaged if this product does not work properly, other
costs resulting from labour charges, delays, vandalism, negligence, fouling caused by foreign material,
damage from adverse water conditions, chemical, electrical or any other circumstances over which
Galvin Engineering has no control. This warranty shall be invalidated by any abuse, misuse,
misapplication, improper installation or improper maintenance or alteration of the product.
TROUBLESHOOTING
PROBLEM
CAUSE
RECTIFICATION
Water is not flowing or
inconsistant flow
Shower arm is blocked with
debris.
Remove debris from shower arm.
