Galvanic Applied Sciences Monitek AT3, Руководство по эксплуатации и установке

Страница: 11 / 34

MODEL AT3 2 – 4
← ---------------------------------------- X -------------------------------- →
↑
|
|
|
|
|
|
Y
|
|
|
|
|
|
↓
Figure 2-2: SYSTEM ENCLOSURE MOUNTING PATTERN
Table 3-1: Window Width Guideline.
ENCLOSURE TYPE X (INCHES) Y (INCHES)
NEMA4X, PLASTIC 12.00 18.90
NEMA 4X, STAINLESS STEEL
8.00 ACROSS END HOLES OF TOP AND
BOTTOM BRACKET.
2.50 ACROSS TWO MIDDLE HOLES OF
SAME BRACKETS
16.75
NEMA7, EXPLOSION PROOF 19.75 11.00
CONNECTING THE CABLES
After the system is mounted, only three cables need to be connected to complete the installation
process. Connect the transmitter and receiver cables to the preamplifier and the appropriate
connectors on the AT3. Then plug the power supply cable to an AC outlet to power up the AT3
monitor. Connectors supplied with the system enclosure will seal the conduit to the box.
The system is now ready to be checked out and adjusted. Refer to Section III - Operation.