tip ring sleeve
male XLR
Back Panel Features
MB Head to MBP cable
1
2
3
4
5
410MBP
● 500 watts
● 4x10” neodymium speakers
● 24.5” x 23.5” x 14.75
● 48 lbs.
212MBP
● 500 watts
● 2x12” neodymium speakers
● 26.75 x 19.5” x 14.75”
● 39 lbs.
115MBP
● 200 watts
● 1x15” speaker
● 23.5 x 19.5” x 14.75”
● 37 lbs.
112MBP
● 200 watts
● 1x12” speaker
● 17.75 x 15.25” x 14.75”
● 32 lbs.
MBP Specifications
Horn:
The
horn settings on the MB Combo are not
sent to the MBP cabinet. Use this switch to engage or
disengage the horn on the MBP. This feature is not
available on the 112MBP.
Chain Out:
This XLR output is used to send your
signal to an additional MBP cabinet. This connection
can be made with a standard mic cable.
Chain in:
This XLR input is used to connect the MBP
to a Chain Out equipped GK product.
AC Receptacle
: The detachable power cord connects
here.
Power Switch:
Pressing this button turns the
amplifier on and off. In the on position, the ring
surrounding the button will light red during power up
then changes to blue, indicating the amp is ready for
normal operation. Should the amp experience a fault
(over heat or over current) the amp will mute and the
ring will light red until the condition is corrected. In
the off position the amplifier is still connected to the
AC mains.
AC INPUT
1 0 0 V - 1 2 0 V / 5 0 - 6 0 H z
212MBP
500W Powered Cabinet
CHAIN OUT
FROM GK
COMPATIBLE
MODEL
CHAIN OUT
FROM GK
COMPATIBLE
MODEL
AVERAGE PWR: 128W
FULL PWR: 580W
HORN
ON
OFF
POWER
1
2
3
4
5
The MBP powered enclosures are optimized to
interface with any Gallien-Krueger product equipped
with a chain output. All EQ and volume settings
made on the primary unit are sent to the MBP,
ensuring uniform output and tone. Up to three MBP
enclosures can be linked together, allowing the user
to create the ultimate “Rig.”
Connecting your MBP to a MB Combo:
Using a standard XLR microphone cable, connect the
Chain Output located on the rear panel of your MB
Combo to the Chain Input of your MBP enclosure. If
connecting multiple MBP enclosures, the Chain
Output of the MBP is connected to the additional
MBP’s chain input.
Connecting your MBP to an MB Head:
When connecting an MB head to an MBP cabinet, a
cable with a male 1/4” Tip/Ring/Sleeve to a male
XLR end must be used. Plug the 1/4” TRS into the
Headphone/Line Out/Chain Out jack of the MB head
and press the corresponding button to the 2 position,
Line Out/ Chain Out.
MBP Series
