11
700RB Series
Rear Panel Controls
1- AC Receptacle:
The power cord is detachable and plugs in here.
2- 380W Amp Only:
380W power amp output for Full-Range operation
only. They deliver 380 watts into 4 Ohms. Lower
impedances should not be used. Each jack has a
minimum of 8 Ohms each. Higher impedances such
as 8 Ohms, 16 Ohms, or No Load are acceptable. No
damage will result from operating the amplifier with
the speakers disconnected.
3-
Speakon Outputs:
Enables BI-AMP operation by connecting a GK-RBH
Series cabinet with the provided 4 conductor Speakon
cable. This connects the 50W amplifier allowing the
Tweeter control on the front panel to control the signal
going to the horn. See Bi-Amp and Normal Operation
on page 7 for more information.
Caution:
Do not connect a Speakon cable labeled “Bridge
Mode” to the 700RB. This may result in damage to
the amplifier.
Maximum Recommended Load:
One 4 Ohm or two 8 Ohm cabinets on the 380W Amp.
One or two 8 Ohm horns on the 50W Amp.
CAUTION:
UNDER NO CIRCUMSTANCES
SHOULD THE 380W AMP AND
THE 50W AMP BE CONNECTED
TOGETHER OR BE CONNECTED
TO THE SAME SPEAKER !!!
11
Rear
Panel
Controls
3
2
1
