Gallet VEN 12 Blizzard, Инструкция по эксплуатации, Страница: 18 / 28

EN - 18
1
P1
P2
P3
P4
P5
P6
P7
P8
P9
P10
P13
P15
P11
P12
P14
P16
III. INSTRUCTIONS FOR USE
Assembling of unit (see Fig. 1)
Take all parts out of the box and remove all packing material.
1) Unscrew the grill screw P7 and blade screw P9 from motor unit P1 .
2) Place the rear grill P6 onto the motor unit P1 and screw this part by grill screw P7 .
3) Place the fan blade P8 onto the motor shaft P16 .
4) Screw on the blade by the blade screw P9 in an anticlockwise direction.
5) Fasten the vane P14 on the front grill P10 by swivel adjustment screw P13 (if not
already fitted at the factory).
6) Once finished, put the front protective cover P10 on the rear protective cover P6 and
secure it with buckles P12 and screw P13 .
7) If needed, you can adjust the air flow angle by the joint P3 .
Note:
Apply reverse procedure to disassemble the unit.
Velocity control and selection
Plug the assembled fan into wall socket.
Turn on the fan by pressing one of the four buttons on the fan base P5 .
First button switches the fan off. Description of buttons:
Button (3) – High air flow velocity
Button (2)
– Medium air flow velocity
Button (1) – Low air flow velocity
Button (0) – Off
Oscillation
For run the oscillatoin (rotate from side ti side) press the oscilation knob
P2
. To stop oscillation,
pull the oscillation knob P2 out.