Gallet Lestre VEN 76S, Инструкция по эксплуатации

Страница: 23 / 36

EN - 23
EN
P1 Front grill P11 Shaft
P2 Blade P12 Speed regulating knob/selector
P3 Rear grill P13 Grill nut
P4 Motor cover P14 Blade nut
P5 Oscillating knob P15 Clip
P6 Motor P16 Base
P7 Screw P17 Plastic feet
P8 Extension pole P28 Screw and nut
P9 Height adjustment nut P19 Adjustable joint angle
P10 Base tube P20 Supply cord
III. INSTRUCTIONS FOR USE
Assembling of unit (see Fig. 1)
Take all parts out of the box and remove all packing material.
1) Insert the base tube P10 into the base P16 and secure it by slight pushing.
2) Assemble the base tube P16 and mount the plastic feet P17 . (you will hear snapping
sound).
3) Slide out the extension rod P8 from the main base P10 and mount the engine unit P6
on its top.
4) Place the motor and switch box firmly on the top of the extension pole, and tighten
screw
P7
5) Unscrew the gril nut P13 from motor cover P4 and put the rear grill P3 on the motor
cover
P4
. After this tighten the rear grill by nut
P13
.
6) Place the blade P2 and tighten by blade nut P14 .
7) Once finished, put the front protective cover
P1
on the rear protective cover
P3
and
secure it with buckles P15 and screw with nut P18 .
8) Adjust the required height and secure in place by tightening the nut
P9
.
9) If needed, you can adjust the air flow angle by the joint P19 .
Note:
Apply reverse procedure to disassemble the unit.
Velocity control and selection
Plug the assembled fan into wall socket.
Speed is controlled by setting the speed regulating Speed regulating knob
P12
to the
desired position within the interval 1-2-3.
Speed regulating knob switches the fan off. Description of knob.
Button (3)
– High air flow velocity,
Button (2) – Medium air flow velocity,
Button (1)
– Low air flow velocity,
Button (0) – Off.
Oscillation
For run the oscillatoin (rotate from side ti side) press the Oscilation knob
P5
. To stop
oscillation, pull the oscillation knob P5 out.