Gallet CCH 210, Инструкция по эксплуатации

Страница: 23 / 36

EN - 22 EN - 23
EN
– the temperature interval is 30 - 60 °C.
Use:
• Put the wool insert
A1
inside the heating foot
A
.
• Place the heating foot on dry floor so that you can comfortably sit down (on a chair,
armchair, etc.).
• Put your feet in the heating foot.
• Connect the appliance to mains.
• Switch on the appliance by long pressing B2 button.
• Set the operation temperature by pressing
B3
button. The temperature is shown on
B1
display. We recommend beginning with a lower level of power and then increasing it as
needed.
• After 90 minutes the heating pad switches off automatically.
• The heating foot may be switched off at any time by pressing and holding B2 button
(about 3 secons) .
IV. MAINTENANCE
Wipe
B
controller with a damp cloth. Clean the heating foot
A
with a damp cloth soaked
in a solution of water and small amount of a cleaning agent. Then let the heating foot
thoroughly dry. The heating foot A must not be machine washed. The wool insert A1 may
be machine washed. Wash machine water temperature should be 25 °C to 40 °C. We
recommend the temperature of 30 °C. After washing, let the wool insert thoroughly dry.
V. TROUBLESHOOTING
Error messages:
Shown on display Problem Solution
„P“
The controller connector is not
properly connected to the foot
Check the connector
connection
„E“
Internal circuit of the foot is
damaged
Contact the authorised
service centre
The device does not work
-
Check whether the wall outlet is powered. You can use another electrical appliance to do so.
-
Make sure the power cord is not damaged.
VI. TECHNICAL DATA
Voltage (V) / Input (W) shown on the type label of the appliance
Weight (kg) about 0.59
Protection class of the appliance II.
Size of the product (mm) 310 x 250x 270
Input in off mode is < 0.50 W
VII. LEGISLATIVE & ECOLOGY
The manufacturer reserves the right to change the technical specifications and
accessories for the respective models. Product image are for illustrative purposes only.
WARNINGS AND SYMBOLS USED ON THE APPLIANCE, PACKAGING OR IN THE
INSTRUCTIONS MANUAL:
WARNING:
DO NOT USE THIS PRODUCT NEAR WATER, IN WET AREAS
TO AVOID FIRE OR INJURY OF ELECTRIC CURRENT. ALWAYS TURN OFF
THE PRODUCT WHEN YOU DON’T USE IT OR BEFORE A REVISION.