Gallet BOU 801WB, Инструкция по эксплуатации

Страница: 13 / 20

ENG - 13
ENG
Let the kettle cool down completely before cleaning or storing.
Unplug the unit when it is not in use, before filling in /pouring out water, moving from one
location to another or before cleaning.
Do not allow the cord or the product itself to touch hot surface and make sure (that) it is pla -
ced in such a way that the unit cannot accidentally be reversed by pulling the power cord.
Do not operate the product with the damaged cord or the plug. Never try to repair it on your
own. The cord or plug replacement should be done in authorized service center only.
Do not operate the kettle if it has been dropped or damaged. Take it to an authorized service
center for examination and repair.
Never disassemble the product; incorrect reassembly can increase the risk of electric shock
when the kettle is used. All repair work should be carried out only by an authorized service
center.
Do not use the kettle without filter.
Do not use the appliance outdoors.
The appliances are not intended to be operated by means of an external timer or separate
remote-control system.
Important !
As there is the risk of burns, always close the lid and lock it properly when you are going to
turn the kettle on. Never open the lid while hot water is inside and /or the steam density is too
high.
The lid or outer surface may get hot when the appliance is in operation. The temperature of
accessible surface may be high when the appliance in operation.
Before switching on the kettle ensure that the water level is between MIN and MAX marks
only.
There is a cut-off device that works if the kettle is overheated. It switches the kettle off when
there is no water inside or the water level is too low. Wait until the kettle cools down comple -
tely to start boiling after the cut-off device was activated. The kettle will not turn on while it is
too hot. Before switching on the kettle always check that there is water inside the kettle and
the water level is not too low.
Fill the kettle with cold water only.
Switch the kettle off before removing it from the basement.
The kettle must be used with the original basement only.
If the kettle is overfilled, boiling water may be ejected. The water must not overload above the
MAX mark level on the kettle!
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•