Gallet ASP 9560, Инструкция по эксплуатации

Страница: 29 / 36

ENG
ENG - 29
Remove the HEPA Rinseab -
le “Tap Clean” filter from the
dust cup.
Vigorously “Tap Clean” the
HEPA dust cup filter on a
hard surface unill no more
dust is observed falling out.
Alternatively the HEPA filter
may also be washed by run -
ning it under the tap allowing
the water to run on the dirty
side.
IMPORTANT: PLEASE NOTE:
The Rinseable “Tap Clean” HEPA Dust Cup Filter will stop most of the tiniest dust particles and
airborne allergens from re-entering the air you breathe. In fact it stops 99.97% of all particles
as small as 0.3 microns-many times smaller thana human hair! Because of this incredible fil -
tration performance, the HEPA Dust Cup Filter will quickly accumulate may fine dust particles
inside the white filter folds that are difficult to see but which will eventually block or reduce your
suction power, if not cleaned properly. We recommend washing it once a month or when suction
appears reduced.
The HEPA filter operating lifetime corresponds to about 10 to 15 washing cycles. After that, the
filter looses its performance and it should be replaced.
WARNING:
Always empty the dust cup and clean the HEPA dust cup filter before each use and during pro -
longed usage. Never over fill the dust cup. Remove dirt and clean the HEPA dust cup filter each
time the dust cup is emptied during prolonged usage or risk motor damage.
Cleaning the HEPA filter frame:
Rinse the frame in lukewarm water by just running it under
the tap to remove any dust that is adhering to the frame.
DO NOT place in dishwasher.
Make sure that the filter frame is completely dry before
replacing into the dust cup.
Pre-motor Filter and Exhaust Filter removal, cleaning and
replacement