3
Universal Mount Installation
(Optional Equipment)
(Detailed Instructions & Video)
The universal bench mount consists of (1) pair of brackets for a 60” machine and (2) pair
of brackets for a 96” machine. The brackets are paired so that there is a left-hand and
right-hand bracket, (refer to photo at bottom of page) indicated by the small tab on each
bracket that favors one side as viewed from the front.
Installation for 60”:
Locate the centerline of the bench and make a mark. Place the left-hand bracket
(identified by the forward most tab on the left outside edge) where the outside edge of the
top mounting plate is 21.125
″
to the left of the centerline and secure it to the bench using
the 2 holes at top of the mount. There are (3) additional holes on the face of the mount if
you do not want to drill on top of your bench.
Place the right hand bracket 21.125” to the
right of the centerline. Please confirm that the distance between the 2 small tabs in the
front are 39” apart inside to inside. These tabs will “trap” the machine to reduce
movement. Your mounts come with (2) metal
¼
-20 screws that allow you to apply just a
little pressure. (pictured below)
Left bracket
tab outside
Right bracket
tab outside
42.25”
for 60”
Metal screws
