3. If the first post is a plastic post (B), hook the loop of the
wire to the desired wire height behind the plastic wire
holder.
In case you have placed a wooden starting pole, hook the
loop into the eye of the first ring insulator (C1) which you
have attached to the desired wire height in the wooden
pole.
4. See figure step 1, unroll the wire towards the next plastic post (B) and place the wire in the wire
holder, at the same height, repeat this until the end of the fence.
At the end, insert the wire through the ring insulator eye on the end post (B2) and insert the wire to the
upper ring insulator for the next wire height. Follow the method and direction according to the arrows
in the image.
If you use the plastic post as the end post, hook the wire into the wire holder and bring the wire to the
upper wire holder (B3) and then to the adjacent post again.
Do
not
cut the wire but guide the wire through the ring insulator or wire holder to the next wire height
and then, via the plastic posts, back to the starting post, continue this process for each post and next
wire height.
Hook the wire through a loop attached with a Vidoflex wire connector in the last insulator or wire
holder, do not tighten the wire too much here, hand tight is sufficient.
Your fence is now ready to be connected to the electric fence device.
Step 4 – Installation of the electric fence device
Correct installation is essential for proper, functional and safe operation of your electric fence. The electric
fence device (A) should be placed near a power outlet and the fence, but always in a sheltered environment
such as a shed or under a roof and always protected from direct weather.
Warning!
Do not connect the device to the power outlet yet.
Step 5 – Connecting the earth pin and grounding
The supplied (steel) grounding wire (approximately 3 m) for attaching to the earth pin (E) and the connection
cable to the fence (F) is specially intended to establish the connection between the electric fence device, the
fence and the earth pin.
Tip:
If the supplied cables are too short, you can order the
‘grounding cable’ specially designed for this
through the gallagher.eu webshop. (e.g. item no. 065028, Grounding cable 1.6 mm 10 m on a roll.)