Galibier Design Gavia, Руководство по установке, Страница: 7 / 24

2
2.2 Unpacking and Organizing the Components
2.2.1
Unpacking
“Top off” the Battery Charge:
Immediately after unpacking Box #3, top off the battery charge. Your battery
shipped in a fully charged state. Strictly speaking, this will not be necessary.
North America : Plug the female end of a standard (2 prong) extension cord into
the battery and the other end into a 115 VAC outlet. Follow the instructions in
the charger’s manual and use the lowest charging rate available (always a good
idea with any battery.
Unpacking Hints - North America (cartons):
This section to be completed later.
Unpacking Hints - Overseas (crate/cartons):
This section to be completed later.
2.2.2
Organize the Components According to the Assembly Steps
The major components (base, platter, motor pod) are wrapped in plastic stretch
wrap to protect their finish from fine scratches during transport.
We advise leaving this stretch wrap in place on the turntable base until after you
have installed the brass bearing housing and have attached the ground wire to
the underside of the bearing.
This last operation requires turning the turntable base upside down.
Assembly
Step
Part Box # Inner Box
Platter Platter 1 n/a
Base / Bearing Turntable Base
Tip toes
2 n/a
Base / Bearing Bearing
Ground wire
3 8” x 4” x 4”
Base / Bearing Strap Wrench
Bearing oil
3 n/a
Motor Drive Motor Pod
Umbilical Cord
Tip Toes
3 9” x 9” x 6”