Points for Attention
Menu Setting
This unit is in compliance with the communication control standards, so the following
1st Press MENU button : CHANNEL mode, you can press Up/Down key to select your channel;
rules and regulations must be observed:
2nd Press MENU button : CTCSS & DCS mode, 1-99 sub-channel, you can press Up/Down key to select your sub-channel;
1. While you use the unit, we do not guarantee that secrets will not be disclosed in
3rd Press MENU button : VOX mode, voice activate PTT with off, 1-3 level selection, you can press Up/Down
communication;
key to select your ON-OFF with 1-3 VOX level selection
2. There must not be any harmful interference to be caused when you use this unit.
4th Press MENU button : TIME DISPLAY mode, 12 HOURS selection. (“Blank” display show as 24:00 to 11:59 ,
This unit must accept interference, if any;
“pm” display show as 12:00 to 23:59)
3. Any unauthorized changes in or adjustment of the built-in setup such as changing
5 h Press MENU button : TIME DISPLAY mode, MINUTES selection. (“Blank” display show as 24:00 to 11:59 ,
frequency, launching power, or extending antennas, etc beyond the specified range are
“pm” display show as 12:00 to 23:59)
illegal acts, or even lead to a breach of telecommunication management and control;
6th Press MENU button : CLOCK ALARM mode, you can press Up/Down key to select your clock alarm ON-OFF. If you
4. Do not use this unit where there is danger, including gas stations, hospitals, airports
select ON, you need continue to select the clock alarm time.
or any other gas or electric places without shield protection;
7th Press MENU button : CALL ALERT TONE mode, you can press Up/Down key to select your call
5. Do not use any detergent or thinner to wipe or clean this unit. Only use dry,
tone (9 call tome selection).
alkaline-free or well-distributed soft cloth to clean batteries, etc;
8th Press MENU button : VOICE SCRAMBLER mode, you can press Up/Down key to select voice scrambler ON-OFF.
6. You can have an ideal talking effect. Please put the antenna upward during the
9th Press MENU button : STOP WATCH mode, you can press Up/Down key to start the time counting of stop watch,
intercommunication of the talker, and keep it 5 centimeters away
then press Up/Down key to stop the time counting of stop watch.
from your face talking in your normal voice;
10th Press MENU button : SOS mode, you can press Up/Down key to select SOS emergency alarm ON-OFF with 3-5, 5-5
7.This talker has inner cell protection functions. If you do not use it for long,
10-5 alarm time selec-tion. If you select ON with desired alarm time, then you see SOS
please take out the cells;
icon constant,To activate SOS emergency alarm, you need press DOWN key until SOS icon become
flash, then alarm sound will be continue calling until you press DOWN key again and see
Battery Installation
SOS become constant, the alarm sound will be Quit & stopped.
Battery (attached with the unit) is applied to this talker. The installation
Special Key Setting
and replacement of cells are described as follows:
1. Press down the fixed button on the side of the battery cover of this unit to
● POWER/MENU key :
open the battery cover;
Press POWER/MENU button : Continue Press this key to approximate 3 second, "Key Lock" function will be activate.
2. In the time of installing the new battery, please place the batteries cell
Continue Press this key to approximate 5 second, this walkie wil be turn ON, or turn OFF (go to Time Mode).
into the cell compartment. In installation, please note the polarity within the
● FM RADIO mode :
compartment and the cell itself; and
Press & Hold UP button : Activate FM radio, you can press Up/Down key to select your desired radio channel
3.
Put the cell compartment where it is and lock tightly the fixed button for the cell cover.
from 87.50MHz to 108.00MHz. If you press & hold UP button again, it will exit from radio mode.
Using Earphone
● Lift up the earphone/charger jack cover on the side of the unit;
● Insert the earphone plug into the earphone/charger jack and adjust the location of your earphone;
● Set the talker into the VOX mode. When the VOX function is set to ON, you do not have to keep pressing the
earphone/talk key for any talks. When the VOX function is set to OFF, keep pressing
the earphone talk key for talks; and
! Special Caution: Never inserting indicated USB device for charging,
● When you use your earphone to hear the other side talk, press Up key or Down key to adjust
Or this item si not installed with battery !!!
volume to an appropriate level.
This talker has (Option) USB charging cable and can charge the rechargeable battery in the following :
1. Lift up the earphone /charger jack cover on the side of this unit;
Technical Specifications
2. Connect USB cable (option) into charging devise such as computer or USB AC adaptor.
3. Connect USB cable (Option) to the earphone/charger plug, In the charging process,
License free country: Europe/Hongkong/Japan/USA for your option
the battery icon will be flashed when charging. If it become fully charge, the battery icon will constant.
Channels available: 8/20/21/22 channels for your option
Note: For the first time charging, please charge the rechargeable battery for as long as 12 hours.
Operating frequency: 446/409/422/462MHz
After completion charging, you must take out the USB cable to leave from the radio, it avoid radio
Power: 3.7V lithium battery
become damaged.
Output power: 0.5W maximum
Service life of cells: On the basis of services
Receiving range: up to 7km (in open space but no guarantee)
Low Battery Operation
USB charging: ~ 5V DC
When the battery icon is detected as low voltage, the battery icon bar will reduce and until empty battery bar.
TX power current: ~ 300 mA
When you heard low voltage alert sound, it is necessary to charge the battery otherwise it will work not properly.
RX power current: ~ 100 mA
When you still not charge the battery for certain time, the radio will be auto-off (with time display screen only)
Standby current: ~ 50 mA
It will quite from walkie talkie mode and you should charge the battery at least 6 hours before you use it again.
Time mode current: ~ 5mA
