![background image](http://html1.mh-extra.com/html/galaxy/dx-66v/dx-66v_owners-manual_3283984006.webp)
5. E-TONE.
This control is used to echo effect and intervals of echo
sound.
6. DIMMER (inner dual concentric).
Turns on/off the frequency display,
channel number and the meter lamp. Switch on at minimum brightness,
rotate further to get brighter illumination.
7. RF POWER CONTROL.
Adjust this control to acquire RF power level
you desired in AM or FM transmission.
8. CHANNEL
SELECTOR.
This switch selects any one of the channels
desired. The selected channel appears on the LED readout directly above
the Channel Selector knob.
9. BAND
SELECTOR.
This switch selects A, B, C, D in Hi or Lo band of
operation.
10. BAND SWITCH-HI/LOW.
This switch is used to select High band and
or Low band Frequency Range.
11. CLARIFIER.
Allows variation of the receiver operating frequencies
above and below the cassigned frequency. It may be used to optimize
AM/FM signals as described in the Operating Procedure paragraphs,
operates both TX/RX.
12. R.B./OFF.
When this switch is placed in the ROGER BEEP position,
you radio automatically transmits the audio sign at the and of your
transmission. The listener can note easily your transmission is over
through the sign.
13. MODE (PA/AM/FM) SWITCH.
This switch is used to select PA, FM,
AM mode of operation. The AM or FM mode is normally, but when you
set to PA position, the transceiver acts as a public address amplifier.
Before operating PA, you must first connect an external PA speaker (8
ohm, more than 2W) to the PA Speaker jack on the unit rear panel.
14. FREQUENCY COUNTER.
This frequency counter indicates the
selected frequency you wish to operate on.
15. OFF/NB/NB+.
When the switch is placed in the NB position, the RF
noise blanker also is activated. The RF noise blanker is very effective for
repetitive impulse noise such as ignition interference. If you wish to turn
off the frequency display only set switch to NB+ position.
16. +10KHz FREQUENCY SHIFT SWITCH.
When switch is pressed the
frequency is shifted 10KHz up. On following channels. A channel can
be used by setting this switch to +10KHz position.
10KHz
3 3A
7 7A
11 11A
15 15A
19 19A
17. METER.
This meter indicates received signal strength, transmitter RF
output power and SWR level.
18. CHANNEL INDICATOR.
Numbered LED indicates the selected
channel you wish to operate on.
- 9 -
- 10 -
Содержание DX-66V
Страница 10: ...MEMO MEMO 17 18...