635-SERIES HARDWARE M ANUAL
Chapter-Page
2-63
STEP 8. Connect the Controller CPU to the Network
PC to Controller Communications:
600 CPU uses
TCP/IP
10 Mb Ethernet/Full Duplex
at the port side.
635 CPU uses
TCP/IP
100 Mb Ethernet/Full Duplex
at the port side.
DISTANCE from the Controller to the switch:
conform to TCP/IP specifications (max 300 ft from
Controller to switch; max 900 ft on the local LAN side).
IMPORTANT:
All maximum distance limits are estimates based on clear communication. If
interference exists, distances must be reduced to maintain communication.
8.1 Connect the CPU to the Ethernet LAN
1.
Connect the Cat-5e cable to the CPU board Ethernet Connector ( 10/100 Base-T ).
Figure 49 – 635 CPU: Power, Ethernet, Tamper and Data connections
Diagram shows how to land wiring on connectors.
The Link and LAN LEDs are on the Ethernet Connector and
will flicker as data is detected
on the Network.
The XMIT and RCV LEDs
will flicker as communication occurs.
