Operation of TV8 Portable Sound System
A. Power Supply/Charger
(see page 8)
1. There is a universal AC switching power supply/charger built into the system
that will operate on voltages of 100~240V,50/60Hz. Verify that the voltage to
which you are connecting is in that range and then connect the AC power
cord from the AC IN
(A1)
to the wall outlet.
B. Power Switch and Charge Indicator
(see page 8)
1. Power LED lights constant red under normal operation when power switch is
on. Blinking Power LED indicates 30% of battery power remaining.
2. When charging is almost complete, the indicator will flash RED and GREEN.
After the battery is fully charged, the indicator lights GREEN. The Universal
Power Supply/Battery Charger allows the Traveler to be used anywhere in
the world. The Traveler will operate for an unlimited time on AC power and
for about 6 hours on just battery power. A full recharge of the batteries takes
about 4 hours. The Traveler may be operated while recharging the batteries
without affecting the charge time. If a power failure occurs when operating
on AC, the Traveler will seamlessly switch over to battery power.
C. Mixer
(see the page 8)
1. Master Volume Control.
2. Turn the Treble control
(C2)
counterclockwise to decrease the treble,
and turn clockwise to increase the treble. The center position (straight up)
produces a flat response.
3. Turn the Bass control
(C3)
counterclockwise to decrease the bass, and
turn clockwise to increase the bass. The center position (straight up) produces
a flat response.
4. Mic Volume for wired mic In jack (D3).
D. In/Out Jacks
(see page 8)
1. The system contains Line In, Line Out, and Mic in jacks for connecting
external audio devices.
2. Line In
(D1)
: RCA jacks to connect external audio sources, such as CD/
MP3 players or iPods. The volume of the Line In is controlled solely by the
Master
(C1)
.
3. Line Out
(D2)
: RCA jacks for sending the entire mix signal to other audio
devices, such as recorders, mixers, or power amps.
4. Mic In
(D3)
: XLR or 1/4” (6.3mm) phone jack for wired microphones. Volume
of this input is controlled by Mic In
(C4)
and the Master
(C1)
.
E. Speaker Out:
(see page 8)
1. Used to connect to an external unpowered speaker (8Ω Min.)
