7
AS CK SET UP
-
AS-CK SETUP PROCEDURE
Note:
The word “Transmitter” in this procedure applies to both
the AS-HH5 Hand Held Microphone and the AS-MBP5 Body
Pack with its connected Microphone.
1. Make sure that both the Transmitter and AS1000R
Receiver power switches are in the off position before
beginning this procedure.
2. Install 2 fresh AA batteries into the AS1000R. Attach
headphones to the Green headphone jack. Move the
power switch to the ON position. The LED indicator
should illuminate Red for a few seconds and then go out.
If the LED lights up Green, first double check that the
Transmitter power switch is in the off position. If the LED
remains Green even when the Transmitter is switched
OFF, adjust the group and channel switches until the LED
goes out. This will greatly increase the likelihood that the
Any Spot system will be functioning on a frequency free
from interference.
3. Install 2 fresh AA batteries into the Transmitter. Adjust the
group and channel switches to match the group and
channel settings selected on the AS1000R. Move the
Transmitter power switch to the ON position. The Red low
battery indicator on the Transmitter should flash on and
then go out. The LED on the AS1000R should now
illuminate Green, indicating that it is receiving signal from
the Transmitter. If the LED on the AS1000R does not turn
Green, verify that the Transmitter and AS1000R have both
been adjusted to the same group and channel settings. If
the AS-1000R LED still does not turn Green, please try
selecting a new group and channel on both the
Transmitter and AS1000R to avoid any possible
interference from outside RF sources. Repeat this until
the AS1000R LED turns Green.
4. If using the AS-MBP5 Transmitter, verify that the switch on
the back of the body pack is set to "Mic". Increase the
headphone volume control on the AS1000R slowly while
speaking into the Microphone and listening to the
