XYJGT6070AQFDE-001
27
The test can be carried out in different stages;
⇒
在此模式下，若旋钮不在以上测试位置，则无任何响应；
If the knob is not in the above test position in this mode, there is no response;
◆
退出此模式关闭电源旋钮。
◆
Exit this mode and turn off the power knob.
6.3.2
适用非显示屏机型
Applicable to non-display models
1
）
通电前按住
K1+K2
键不放，通电后直到听到蜂鸣器发出“嘀、嘀、嘀”三声，提示已经进入特殊
选择模式。界面显示：程序选择旋钮指示灯显示当前程序旋钮的位置，同时“启动
/
暂停”指示灯以
1Hz
的频率闪烁。
Hold the K1+K2 button before power on, until the buzzer "di, di, di" is heard, indicating that the special
selection mode has been entered. Interface display: the program selection knob indicator shows the
current position of the program knob, while the "start/stop" indicator flashes at the frequency of 1Hz.
2
）
将程序旋钮转至
P7
位置，按下启动
/
暂停键，程序进入检测模式。所有
LED
指示灯闪烁
3
秒，开
始自动执行检测。
Turn the knob to P7, press the start/ pause button, the program enters detection mode. All LED
indicator lights flash for 3 seconds, and the following detection starts automatically.
3
）
将程序旋钮转至
P8
位置，按下启动
/
暂停键，程序进入检测模式。所有
LED
指示灯闪烁
3
秒，然
后，再次按下启动
/
暂停键，开始单步执行当前旋钮位置所对应的检测。
Turn the knob to P8, press the start/ pause button, the program enters detection mode. All LED lights
flash for 3 seconds, then press the Start/Pause button again to step through the detection
corresponding to the current knob position.
检测流程如下：
The testing process is as follows:
设定
Set up
描述
Describe
预洗阀测试
（
P8
位置）
Pre washing valve
test
(P8 position)
注水设定时间
Water injection setting time.
主洗阀测试
（
P7
位置）
Main washing
注水设定时间
Water injection setting time.
