switch
ront door
on the connecting lever
and the working lever into the switch holder.
(2) Assemble the interlock switch and pilot switch to the switch holder,
they
assembled correctly.
(3)
fix the holder with
screws.
(4) Check the position of the hook and the switch holder.
the door, push and
the Iow and up
of the
door to check whether the door is flexible. it does, back
and front position of the holder should be adjusted.
Provided the up hook is
the door should be pushed
closely to the
and
the holder inside closely
loosen the screw
fix the
then, tighten the
screw and check whether it is
loose. If it is not or the
loose is minor, it
be OK. Open the door, then
it
check whether the hook is in position, if not,
readjustment is needed. If the loose is at
part of the
door, the adjust methods is the same with the above said
steps but the screw is the one
(FIG.4 -
THE
PANEL OF
OVEN
out the power
Take off the
one end of the capacitor and the
light tough switch
control panel
Fig. 4-22
light tough switch
control panel
baseboard with a screwdriver.
Means of dismantling the PC board and door release
mechanism:
(1)
out the terminal
of the PC board.
(2) Loosen out the two screws which fix the control panel
with a
screwdriver (FIG.4 -6).
(3) Take off the control panel.
(4) Take off the three
screws which fix the PC board
as the FIG.4 - 22.
(5) Take off the rangę terminal
as FIG.4 - 24 shown,
that is press the two places according to the arrow
direction at the figurę,
it up about 2mm, then off
the
plastic board.
(6) Take off the PC frame.
(7) Tear off the undried glue of the light touch switch (FIG.4
to assemble the PC board and door release mechanism,
Tear off the undried glue patch of the light tough switch
(1) and (2) as the
and place them into the
rectangle hole of the
of the plastic board.
(2) After uprighted the light tough switch, tear off the
protective paper on the back, and stick it on the plastic
board smoothly.
(3) Tear off the protective paper of the light touch switch (2), and stick the switch on the back of the plastic board
smoothly.
(4) Assemble in the PC frame and PC board as FIG .4
and fix them with three
screwes.
(5) Fix the rangę wires as
the means
the rangę wires first,
that its notch is tallied with
the flange of the
seat, then, press it down to its normal
15
Fig. 4-23
Fig. 4-24
