Galanz GL1BO24FSAN, Руководство по установке, Страница: 9 / 23

INST
ALLA
TION REQUIREMENTS
INSTALLATION REQUIREMENTS
7
TOOLS AND PARTS
Gather the required tools before starting installation. Read and follow
the instructions provided with any tools listed here.
Tools Needed:
• Tape Measure
• Straightedge
• Pencil
• Phillips Screwdriver
• Level
• Wire Cutters and Wire Stripper
• Hand or Sabre Saw
• 1 ” Hole Saw
• D rill and Drill Bit
• Safety Gloves and Goggles
• Volt Meter (0-240VAC)
TECHNICAL DATA
OVEN DIMENSION MODEL
Electrical Rating and Maximum
Connected Load
SINGLE
OVEN
24” (60 cm)
GL1BO24FSAN
GL1BO24BKAN
GL1BO24SBAN
240 Volts
60 Hz 208 Volts
60 Hz
Amperes Watts Amperes Watts
13.3 3340 11.7 2600
LOCATION REQUIREMENTS
IMPORTANT: Observe all governing codes and ordinances.
• Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance with oven.
• Recessed installation area must provide complete enclosure
around the recessed portion of the oven.
• The oven support surface must be a minimum ¾” (2 cm) thick
plywood platform. The platform must support 100 lbs (45 kg),
and be solid, level and flush with the bottom of the cabinet
cutout.
• G rounded electrical supply is required. See “Electrical
Requirements” section.
• Ele ctrical supply junction box should be located 3” (7.6 cm)
maximum below the support surface when the oven is installed in
a wall cabinet. A 1” (2.5 cm) minimum diameter hole should have
been drilled in the right rear or left rear corner of the support
surface to pass the appliance cable through to the junction box.
NOTE: For undercounter installation, it is recommended that the
junction box be located in the adjacent right or left cabinet. If you
are installing the junction box on rear wall behind oven, it is
recommended that the junction box be recessed and located in the
upper center of the cabinet.
• Oven support surface must be solid, level and flush with bottom
of cabinet cutout. Floor must be able to support a single oven
weight of 129 lbs (59 kg) for 27” (68.6 cm) models.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used will not
discolor, delaminate or sustain other damage. This oven has been
designed in accordance with the requirements of UL and CSA
International and complies with the maximum allowable wood cabinet
temperatures of 194
℉
(90
℃
).