(3) Cancellation of Commands from Remote Control Switch after Forced Stoppage
By using the signal from a building management system, the air conditioners can be stopped and the
individual commands from the remote control switch are canceled.
The basic wiring and time chart are shown below.
(In Case of “Cancellation of Commands from Remote Control Switch after Forced Stoppage” Input to
At this function, the B contact can be used by the optional setting (chapter 6 .3 Table A item Cb (13):01)
of the remote control switch.
The time chart when using the B contact is shown below.
Signal to
Control by R.C.S
Unit Operation
Time Chart
Time
SS3
X1
Power
Source
Control Circuit
SS3: Forced Stoppage Sw.
Wiring Diagram Example
Control by R.C.S
Unit Operation
Time Chart
Time
NOTES:
1. Picking up signal within 10 seconds after power supply is turned ON is not available due to initializing of
components.
Do not change the signal (RUN/STOP) in this period.
2. Remote Control Switch is required for this function.
NOTES:
1. Picking up signal within 10 seconds after power supply is turned ON is not available due to initializing of
components.
Do not change the signal (RUN/STOP) in this period.
2. Remote Control Switch is required for this function.
,Setting indication 0)
Terminal board
COM
X1
Signal to
(Setting indication 0)
8
