Gait Up SA
EPFL Innovation Park, Bat C. CH-1015 Lausanne
www.gaitup.com
TVA CHE-145.136.760
PhysiGait Lab user manual v1.3.1 Date: 29.04.2019
Copyright ©2018, All Rights Reserved - Gait Up SA. CH-1015 SWITZERLAND
10
www.gaitup.com/support).
Copy trial recordings to your computer: Physilog® is not the best place to keep and save
important data. Gait Up cannot be hold responsible if data stored on the sensor are lost.
Physilog®5 can be used outside. Do not use Physilog®5 to measure water-sport
activities without additional waterproofing.
Storage: Store in a cool (0°C
– 30°C) and dry place. The provided box is the perfect
place for your sensor.
Cleaning: Sensors can be cleaned gently using alcohol wipes. Before you clean the
device make sure it is turned off and disconnect all cables. Alcohol used in excess may
damage the sensor’s waterproofing. Make sure to use wipes and not put liquid alcohol
directly on the sensor. Do not clean the USB entry with alcohol.
Each sensor is individually calibrated by Gait Up and they do not need yearly
recalibration for gait measurements.
Do not throw Physilog® sensors in the normal trash, dispose of it properly considering
local laws and rules about electronic waste and batteries.
Contact Gait Up’s customer
support for more information about elimination of Physilog®.
Make sure to know which Physilog® file corresponds to which trial for your analysis
–
First digits of file name are automatically incremented (exceeding 999 and new date
resets the increment back to 1). Note that date of file generation (recorded between one
start and stop of the Physilog®) is visible in the X
LS file and the Matlab structure “header”.
If you wish to adapt internal date and time of the Physilog®, read the corresponding
section of the user manual of Physilog®5.
Do not remove the “conf.bin” file from the Physilog, otherwise it will create empty files
(no sensor activated). If this happens, recreate a configuration in the Research ToolKit
software or contact Gait Up's customer support. For firmware v1.1.0 upwards, a default
configuration based on original configuration is created to compensate the removal of
the conf.bin file and the “slave.txt” file is no longer needed.
Do not introduce pointy objects into the small hole besides the USB entry, this irreversibly
damages the waterproofing of the sensor.
