Pub.: 42004-692L2C
M
ODEL
DEX-103
AND
DEX-203
D
RILLER
’
S
I
NTERCOM
S
TATIONS
Page 5 of 13
f:\standard ioms - current release\42004 instr. manuals\42004-692l2c.doc
11/10
Mounting
The station consists of two enclosures that
are connected by a union. The mounting
location must be a flat, vertical surface that
provides proper clearance, rigidity and
strength to support the station.
The suggested mounting height for stations is
54 inches (137 cm) up to the center of the
factory-sealed enclosure.
To maintain the explosion-proof integrity of
these stations, they are designed with all
mounting hardware located outside the
enclosures. Refer to Figure 3 for mounting
hole and slot dimensions.
Securely fasten the factory-sealed and
termination enclosures to the mounting
location using steel mounting bolts and
washers, or washer-head bolts (hardware not
included).
Conduit Installation
Install the conduit using an approved
electrical conducting-type lubricant on the
threads. The termination enclosure on the
station has one conduit entry on each side
and two on the bottom of the enclosure.
All ATEX approved models contain M25 metric conduit entries. The bottom entries are plugged from the
factory and can be removed to allow use of the entry. Refer to Figure 2 for locations. All unused conduit
openings must be plugged using a close-up plug approved for the specific hazardous location where the
enclosure is used. All conduit connections must meet minimum thread engagements as specified by the
applicable electrical codes.
Figure 3. Rear view showing mounting slots