Gaggenau VI 482 103, Инструкция по эксплуатации

Страница: 31 / 36

31
Trouble shooting
en
3
Trouble shooting
Trouble shooting
Usually, faults are small matters that are easy to
eliminate. Please read the information in the table
before calling the after-sales service.
Notes
– If the fault code is not listed in the table, disconnect
the hob from the mains power supply and wait
30 seconds before reconnecting it. If this code is
displayed again, contact the technical after-sales
service and specify which fault code has appeared.
– If a fault occurs, the appliance will not switch to
standby mode.
Display Possible cause Solution
None The power supply has been disconnected. Use other electrical appliances to check whether a
short circuit has occurred in the power supply.
The appliance has not been connected as
shown in the circuit diagram. Make sure that the appliance has been connected as
shown in the circuit diagram.
Electronics fault. If the fault cannot be rectified, inform the technical after-
sales service.
A signal sounds. The control panel is wet or an object is cov-
ering it. Dry the control panel or remove the object.
The hotplate has been
switched off. The illumi-
nated ring on the control
knob is flashing. The control knob has not been turned for
an extended period. The automatic safety
cut-out function has been activated. Turn the control knob to position 0. Switch the hotplate
back on.
The appliance is too hot. Read the fault message on the control panel.
The hotplate indicator is
flashing. The cookware is not being detected. Make
sure that the cookware is suitable for use
with an induction hob. Make sure that the diameter of the base of the cook-
ware corresponds to the size of the hotplate. Turn the
control knob to position 0. Switch the hotplate back on.
”ƒ
The electronics have overheated and have
switched off the affected hotplate. Remove any cookware from the hotplate. Once the fault
code goes out, the hotplate has cooled down suffi-
ciently. Turn the control knob to position 0. Then select
the heat setting as usual.
”…
The electronics have overheated and all of
the cooking zones have been switched off.
Ӡ
+ heat setting and sig-
nal tone
There is hot cookware near the control
panel. There is a risk that the electronics
will overheat. Remove the cookware. The fault code goes out shortly
afterwards. You can resume cooking.
Ӡ
and signal tone
There is hot cookware near the control
panel. The cooking zone has been
switched off to protect the electronics. Remove the cookware. Wait a few seconds. When the
fault code on the display goes out, you can resume
cooking.
”‚
/
”‡
The hotplate has overheated and has been
switched off to protect the work surface. Wait until the electronics have cooled down sufficiently
before switching the hotplate on again.
”‰
The hotplate has been operating continu-
ously for an extended period. The automatic safety cut-out function has been acti-
vated. See section
~
"Automatic safety switch-off
function"
.
”Š
The FlexPlus cooking zone cannot be acti-
vated. Touch any touch control to check the fault code. You
can use the remaining cooking zones to cook as usual.
Contact our technical after-sales service.
“Š‹‹‹
“Š‹‚‹
The operating voltage is incorrect/outside
of the normal operating range. Contact your electricity supplier.
—…‹‹
The hob is not connected correctly. Disconnect the hob from the mains. Make sure that it
has been connected as shown in the circuit diagram.
Do not place hot cookware on the control panel.