26
en
Cookware test
Connecting directly
Note:
If you connect your hob directly to the extractor
hood, it can no longer be connected to your home
network as well and you can no longer use Home
Connect.
1
Carry out the following operating steps one after
the other without interruption.
2
Push in one of the control knobs and turn it anti-
clockwise to position
Ž
.
3
Turn the control knob clockwise to position
ª
or
¹
.
4
Turn the control knob anti-clockwise to position
0
.
The illuminated ring on the control knob lights up
blue.
5
Turn the control knob clockwise to position
ª
or
¹
.
On the control panel,
••’
and
’‹¯‚
are
displayed alternately. The illuminated ring on the
control knob flashes blue. The hob is now ready for
registration in the home network.
6
You have two minutes to initiate the connection on
the extractor hood. For more information, refer to
the section entitled "Connecting to the hob" in the
instruction manual for your extractor hood.
The connection process may take a few minutes.
The hob is connected to the extractor hood once
˜‘‚
lights up on the control panel and the
illuminated ring on the control knob lights up green.
The
Ö
symbol is displayed on the hob's control
panel.
Save the connection and exit the settings menu
1
Carry out the following operating steps one after
the other without interruption.
2
Push in the control knob and turn it anti-clockwise
to the
Ž
position.
3
Turn the control knob clockwise to position
ª
or
¹
.
4
Turn the control knob anti-clockwise to position
0
.
The illuminated ring on the control knob goes out.
Control the hood via the hob
In the Home Connect app, you can adjust the behaviour
of your extractor hood depending on whether the hob or
individual cooking zones are switched on or off.
t
Cookware test
Cookware test
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1
Fill the pan with approximately 200 ml water and
place it at room temperature in the middle of the
hotplate that most closely matches the diameter of
the pan base.
2
Go to the basic settings and select the
™„
setting.
‹””
will be lit.
3
Touch the
@
or
A
symbol.
‹¯
will be lit. A signal
tone will sound and the hotplate indicators will be
lit.
The function has now been activated.
¥—¯
will be lit. After a few seconds, the hotplate
displays will show the results for the quality and speed
of the cooking process.
Check the result using the following table:
To activate the function again, select the
@
or
A
symbol.
Result
‹
The cookware is not suitable for the hotplate and will
therefore not heat up.*
‚
The cookware is taking longer to heat up than expected
and the cooking process is not going as well as it
should.*
ƒ
The cookware is heating up correctly and the cooking
process is going well.
* If there is a smaller hotplate available, test the cookware
again on the smaller hotplate.
