Gaggenau VG 415, Инструкция по эксплуатации

Страница: 9 / 56

9
Operating the appliance
en
Individual parts of the wok burner
Ensure that the individual parts of the wok burner are
fitted in the correct position and are straight; otherwise,
this may result in ignition problems or problems during
operation. Fit the burner head such that the
thermocouple is positioned in the corresponding recess
on the burner head. The lug on the burner ring must
engage in the corresponding recess on the burner
head.
Note: If the burner parts are fitted at an angle, the
appliance will not work.
Operating the appliance
Operating the appliance
Notes
– Only use the accessories specified. Do not line the
stainless steel recess (e.g. with aluminium foil).
– The burner and ignition plug must be clean and dry.
– Only light the hotplates if the pan supports and all
burner parts are correctly fitted.
– Do not touch the ignition plug while the gas
appliance is being lit.
– It is important to keep the appliance clean. If the
ignition plugs are dirty, this may cause ignition
problems. Clean the ignition plugs regularly with a
small, non-metallic brush. Take care to prevent the
ignition plugs from suffering any heavy knocks.
– When you cook using a wok, place the wok ring
onto the pan support over the wok burner. Make
sure that the wok is stable on the wok ring when
you are cooking.
– When you switch from setting 3 to setting 4 or
higher, the burner will briefly switch to its maximum
output. This is to optimise ignition between the
burner rings.
– Do not cover the ventilation openings on the rear of
the gas hob.
– When the gas cooktop is switched on, the
electronics open up the gas supply, which
produces a short sound. This is normal.
– In the event of a power failure, the appliance will
not work. The gas supply is shut off.
Switching on
Your gas hob has an automatic quick-ignition function.
1 Place a suitable item of cookware on the pan
support.
2 Push in the control knob and turn it clockwise or
anti-clockwise to the heat setting you require.
The burner ignites automatically.
Turn the control knob to set the heat setting.
(
Burner cap
0
Burner ring
8
Burner head
@
Thermocouple
H
Ignition plug
#
+